Installing a Brick Paver Walkway or Clay Bricks

The use of Bricks or Pavers to create a pathway or patio area matches a home in a way that is unmatched. In addition, setting up a Brick or Paver pathway does not always require a pro.

The secret to setting up a Brick or Paver Walkway is to first properly prepare the area where the bricks/pavers are to be set up. The area must be removed a minimum of a foot down, removing all topsoil and clay soil. In addition, string lines need to be strung on each side of the pathway. The string lines suggest the ended up height of the sidewalk.
As soon as the area has been dug down, 3/4" gravel stone should be laid in and tamped down tightly. Then 2" of sand, or stone dust must be spread over the gravel. Once again the sand/stone dust must be tamped down. Stone dust is preferred. The height between the tamped down sand and the stringline must equate to the density of the brick or paver.

Now that you have a stable base, put a 1" pipeline or ledger board the length of the sidewalk on either side of the pathway. Then utilizing a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will produce a level area to lay the bricks/pavers.

Now place on the level sand/stone dust strips of plastic brick borders. Set up a work on both sides of the prepared location. These strips will function as your pathway border and help to preserve the integrity and shape of the sidewalk. You can get these plastic strip borders at a lot of home enhancement stores. The strips need to be anchored down with 12" galvinized nails. You must sink these nails into the ground and through the strips every foot.

You can then begin to lay the bricks/pavers when this is done. There are lots of patterns you can lay. I especially like the Herring Bone pattern. The secret to laying the bricks/pavers is to guarantee that they here interlock with each other. Always stagger surrounding rows of bricks by 1/2 of a brick to interlock them. This will again assist maintain the integrity of the walkway.

Undoubtedly bricks/pavers will need to be cut or divided when building the walkway. To actually cut/split the brick/paver, lay it in a bed of sand and location the sculpt at a 75 degree angle over the spot where you desire to break the brick. If your walkway has curves you will require to buy/rent a wetsaw.

After installing the bricks, develop the outside edges with extra sand, and then shovel in the topsoil and pack down firmly.
Lastly, spread stone dust over the brand-new walkway and sweep into the cracks. Repeat this process a number of times to make sure the cracks are fully filled. This will complete the interlocking of the bricks and help to eliminate any weed growth. Simply add grass seed to the outside edges and you need to have a gorgeous entrance to your house within a number of weeks.


In addition, installing a Brick or Paver sidewalk does not necessarily require a pro. The key to installing a Brick or Paver Walkway is to very first correctly prepare the location where the bricks/pavers are to be installed. Now that you have a steady base, place a 1" pipeline or ledger board the length of the walkway on either side of the sidewalk. These strips will act as your walkway border and aid to maintain the stability and shape of the sidewalk. Inevitably bricks/pavers will need to be cut or divided when developing the walkway.

Leave a Reply

Your email address will not be published. Required fields are marked *